Beisler 1360-4 - Manual (Page 66)

C-26
Service Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
C.5.21 Adjusting the stepper motor PCB
The PCB that controls the stepper motor is installed in the switchbox.
NOTE - Machine cycle!
Prior to a replacement of the PCB, the machine should be moved ma-
nually back to its basic position to prevent collisions among moving ma-
chine components when the machine is switched back on.
1. Depressurize the compressed-air system of the machine and
disconnect the compressed-air hose of the machine from the on
site compressed-air supply system.
2. Move the cross transport to its basic position.
CAUTION - Damage to electrical components!
The positions of switches on the PCB must not be
changed as otherwise the affected electrical compon-
ents can be damaged or become unusable!
Disconnect the machine from the power supply system
and protect it from accidental reconnection.
Fig. 20: Setting the PCB switches:
1. Set the step number:
• at the DIP switches 1 and 2,
• microstep at the hook switches 6 and 7.
2. Set current lowering at DIP switch 3.
3. Set DIP switch 4 to ON.
4. Set motor phase current by rotating knob 5 to position F.
5. Switch on supply voltage. When the PCB has been set correct-
ly, the LED 8 (ready) illuminates, the ready relay is energized.
C.5
Maintenance
DIP switch 1 DIP switch 2
200 2000 ON OFF
400 4000 ON ON
500 5000 OFF ON
1000 100000 OFF OFF
Rotating knob position Phase current DIP switch 3 Current lowering
F 5.50 A OFF ON
ON OFF
Microstep
Signal 0 = deenergized, Signal 1 = current-carrying
Hook switch open
Signal = 0
Hook switch closed
Signal = 1
Hook switch closed
Signal = 0
Hook switch open
Signal = 1
Fig. 20