Beisler 1360-4 - Manual (Page 85)

D-16
Programming Instructions Automatic Multi-Head Serging Machine 1365-4 Beisler GmbH
D.3
Programming
05 CONTOUR GUIDE UP
Sewing distance traveled at beginning of sewing before the contour
guide is lowered
06 TILL TABLE BLOWING ON
Sewing distance traveled at beginning of sewing before the workta-
ble nozzles are supplied with compressed air
07 DURATION TABLE BLOWING [70]
Distance along which the compressed air transports a sewing piece
09 REDUCED SPEED
Reduced rotational speed that is enabled for the differential transport
using the function SLOW (photocell 12 is the reference point for the
A machine, photocell 13 is the reference point for the B machine)
Moving the cross transport manually
Use this function for the manual transport of a sewing piece from the A
machine to the B machine. When the key is pressed, the two cross
transport stamps are lowered, and the transport moves to the pick-up
position at the B machine; from there, the remaining part of the machine
cycle is initiated automatically and continued.
1. Position the sewing piece below the two stamps.
2. Start the cross transport manually:
• Press the gkey
n
The cross transport moves to the wait position before the B machi-
ne.
3. The automatic machine cycle continues.
Passing thread through needles
This function allows the easy passing of thread through the needles on
both sewing heads. The photocells are switched off so that the sewing
units are disabled. The pressure foot is lowered, the transport units are
raised.
1. Prepare the sewing unit for the passing of the thread:
• Press the hkey
+
2. Pass the thread through needle and picker.
3. Enable the sewing unit:
• Press the hkey