Bolide Dvr Client - Manual (Page 32)

DvrClient Software Operation Manual
- 32 -
You can apply for a DDNS account for free at the web http://www.changeip.com/ or
http://www.dnsexit.com/ or http://www.no-ip.com/ or www.3322.org .
7.3.1.1 Router’s Port Forwarding
If PPPoE is selected, port forwarding is not required. Port forwarding is required when
you select <Static> and <DHCP>. Once you set the relative parameters for Router and
device, now you are allowed to visit and playback the remote record files.
Strongly commend user follow below steps before changing network parameters:
1、 Enter into below router configuration interface;
2、 Input router’s IP address which have be not used in the in-house network.
3、 Set the port of IP address specified to the device shown as Picture 7-11.
4、 The DVR IP address for the intranet should be 192.168.1.101, you should
forward server port (9000) and web port (8080) to this IP address respectively.
Picture7-11
Friendly Reminder: The router’s port forwarding interface may be different, however,
when entering into virtual server, user will always need forward port 8080 and port 9000 of
router to IP address of DVR allocated or automatically captured, and select [All] or [Both]
in corresponding protocol column and save the above setting.
Above steps may differ from the router device depending on the manufacturer.
7.3.2 Sub Stream