Orion System Lead Controller - Manual (Page 4)

Zone
Zone
Step-By-Step Guide
Lead/Lag Controller Technical Guide
4
Step-By-Step Guide
Step-By-Step Guide
This guide will lead you through each step in confi guring your Lead/
Lag Controller. Below is a quick overview of each step.
Section 1: Lead/Lag Controller Wiring & Setup —This sec-
tion explains how to mount and wire your Lead/Lag Controller
properly. It also explains how to set the address and baud rate for
your particular system.
Section 2: Prism 2 Installation —This section explains how to
install Prism 2 software required to program your Lead/Lag Con-
troller. If you are not familiar with the Prism 2 software program,
please refer to the Prism 2 Technical Guide which can be down-
loaded from the Orion Controls website: www.orioncontrols.com/
literature-new.html.
Section 3: Lead/Lag Controller Personalization & Status —
This section explains how to individualize and access Lead/Lag
Controllers when more than one is installed and also provides an
overview of the Lead/Lag Controller Status Screens.
Section 4: Confi guring Analog Inputs —This section explains
how to confi gure analog inputs, individualize analog input descrip-
tions, and calibrate thermistor sensors, and override and clear other
analog input values.
Section 5: Confi guring Binary Inputs —This section explains
how to confi gure binary inputs, individualize binary input descrip-
tions, and override binary inputs.
Section 6: Confi guring Relays —This section explains how to
confi gure relay outputs and individualize relay descriptions.
Section 7: Confi guring Analog Outputs —This section explains
how to confi gure analog outputs, individualize analog output descrip-
tions, override voltages, and cancel overrides.
Section 8: Outdoor Status and Lead Lag Enable —This section
explains the Override Status and Lead/Lag Enable Status.
Section 9: Setting Schedules —This section describes how
to confi gure daily and holiday schedules, perform schedule force
modes, and other scheduling functions.
Section 10: Confi guring Alarms —This section explains how to
confi gure and view alarms.
Section 11: Saving and Copying Setpoints —This section
explains how to save Lead/Lag setpoints to a fi le on your computer
and how to restore Lead/Lag setpoints once you have saved them
to a fi le. It also describes how to Load the Factory Default Settings.
Section 12: Printing Daily Status Reports —This section ex-
plains how to view and print Daily Status Reports.
Appendix A —This appendix provides Sample Confi gurations.
Appendix B —This appendix explains USB Driver Installation.
Index —The index provides page numbers for easy reference to
quickly fi nd the information you need.