Programming the vav/zone controller, Technical guide operator interfaces 46, Status – Orion System VCM User Manual
Page 46
Technical Guide
Operator Interfaces
46
Programming The VAV/Zone Controller
Status
Status Screen #1
HC Box v1.04 IDxxxx
Occupied Mode
Vent Mode
Belongs to Group # 1
Line 2
Unoccupied Mode
Occupied Mode
Override Mode
Override Pending
Damper Calibration
Remote Signal ON
Group Override
Line 3
OFF Mode
Vent Mode
Cooling Mode
Heating Mode
Sensor Fail Mode
Line 4-
Belongs to Group # xx
No Group Affiliation
Status Screen #2
HC Box v1.04 IDxxxx
Zone Temp..: xx.x
°
F
Cooling Spt: xx.x
°
F
Heating Spt: xx.x
°
F
Line 2
Current Zone Temperature
Line 3
Currently active Cooling Setpoint based on the current
Occupied / Unoccupied mode of operation.
Line 4
Currently active Heating Setpoint based on the current
Occupied / Unoccupied mode of operation.
Status Screen #3
HC Box v1.04 IDxxxx
SlideOffset: xx
°
F
H/C Demand.: xx.x
°
F
Line 2
If the optional Setpoint Slide Adjust is installed on the
Flush Mount Wall Sensor, this line will display the
current amount the Slide Offset is affecting the
Heating and Cooling Setpoints.
Line 3
Current Heating or Cooling Demand in the Zone
based on the current Heating and Cooling Setpoints
when compared to the current Zone Temperature.
Line 4
Blank
Status Screen #4
HC Box v1.04 IDxxxx
Supply Air: xx.x
°
F
Box Air..: xx.x
°
F
Line 2
Current Supply Air Temperature received via
broadcast from the DX Air Handler or from the Box
Controllers own installed Box Air Temperature Sensor
connected to the AUX input of the VAV/Zone
Controller board.
Line 3
Current Box Air Temperature.
If you have configured the VCM Controller to
broadcast the Supply Air Temperature to the VAV/
Zone controller and don’t have a Box Air Temperature
Sensor attached to the AUX input on the VAV/Zone
controller board, this line will display the Supply Air
Temperature the same as line 2.
If you have a Box Air Temperature Sensor attached to
the AUX input on the VAV/Zone controller board, this
line will display the Box Air Temperature at the
location where the Box Air Temperature Sensor is
installed.
Line 4
Blank