Verilink AS56/56Plus (896-502588-001) Product Manual - Manual (Page 45)

Access Syst em56 Self-Testing
AS56 and AS56 Plus User Manual 3-21
Confirm that the Seconds/Test is properly incrementing and then depress
UP to confirm that the Errored Seconds is not incrementing. If the unit is
receiving errored seconds, confirm your configuration and run the self-
testing again. If the unit still indicates “errored seconds”, contact our
Technical Assistance Center.
Turn Off the BERT and the Local Loop.
Cycle through the Diagnostics menus and confirm that all test functions
(loops and BERT) are Off. (If necessary, turn them Off).
If the unit is being used in a point-to-point configuration, configure and
self-test the remote unit. If the unit is being used in an Integrated Access,
Fractional T1 environment, configure and self-test all remaining units.
NI Diagnostics
BERT......:_Off
DOWN to display:
NI Diagnostics
BERT......:_On
If necessary, SELECT
to display:
NI Diagnostics
Err Secs.:_00000
DOWN and SELECT
to display:
NI Diagnostics
Sec/Test.:_00000
DOWN as required and
SELECT to display: