Verilink AS56/56Plus (896-502588-001) Product Manual - Manual (Page 49)

Line Testing
AS56 and AS56 Plus User Manual 3-25
Line Testing
This section discusses line testing for point-to-point configuration and
Fractional T1 Integrated Access.
Point-to-Point
Configuration The line testing can also be performed via either the Acces s System56
control panel or an external terminal or PC. The instructions belo
assume that the unit is using the front control panel. Chapter 6, Auxiliary
Ports, describes usage of an external terminal.
Confirm that both ends are configured, self-tested, and connected to the
network. Confirm that the
ALARM indicator is extinguished at both ends.
If not, review both configurations and repeat both self-tests. If either
ALARM indicator remains illuminated, contact our Technical Assistance
Center. Once the ALARM indicators are extinguished, proceed as follows.
T1/FT1 Mode Line Testing
Main Menu HH:MM
_Diagnostics
From Main Menu,
UP/DOWN to
display:
Diagnostics
_Ntwk Port
SELECT to display:
NI Diagnostics
Local Loop..:_Off
SELECT to display: