Verilink DIDCSU 2912 (880-502646-001) Product Manual - Manual (Page 2)

ii Verilink DIDCSU 2912 User Manual
Copyright Notice Copyright  1999 Verilink Corporation. All rights reserved.
This document does not create any express or implied warranty about Verilink or
about its products or services. Verilink’s sole warranty is contained in its product
warranty. The end-user documentation is shipped with Verilink’s products and
constitutes the sole specifications referred to in the product warranty. Verilink has
made reasonable efforts to verify that the information contained herein is accurate,
but Verilink assumes no responsibility for its use or for any infringement of patents
or other rights of third parties that may result. The customer is solely responsible
for verifying the suitability of Verilink’s products for its use. Specifications are
subject to change without notice.
Trademarks Verilink is a registered trademark of Verilink Corporation. Access System 2000,
WANscope, VeriStats, and FrameStart are trademarks of Verilink Corporation.
Any named products herein are trademarks of their respective companies.
FCC Requirements This equipment has been tested and found to comply within the limits for a Class A
digital device pursuant to Part 15 of the Federal Communications Commission (FCC)
rules. These limits are designed to provide protection against harmful interference
in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the user manual, can cause harmful
interference to radio communications.
There is no guarantee that interference will not occur in a particular installation. If
this equipment causes harmful interference to radio or television reception—which
can be determined by turning the equipment off and on—try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Lithium Battery The lithium battery referred to in the following notices is contained inside the clock
chip.
English DANGER!
The battery can explode if incorrectly replaced! Replace only with the same or equiv-
alent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer’s instructions.
DANGER!
To avoid electrical shock in case of failure, the power supply must be installed by a
professional installer. The terminal labeled with the ground symbol ( ) on the
power supply must be connected to a permanent earth ground.
CAUTION!
Interconnecting circuits must comply with the requirements of
EN60950:1992/A2:1997 Section 6.2 for telecommunications network voltages
(TNV) circuits.
Français ATTENTION!
Une explosion peut se produire si la batterie est remplacée d’ une façon incorrecte!
Remplacez-la seulement avec le même modêle de batterie ou un modèle équivalent
selon les recommendations de manufacture. Disposez de les batteries usées selon les
instructions de manufacture.
ATTENTION!
Pour éviter choc électrique en cas de insuccès, la provision de pouvoir doit êtré
installé par un installeur professionnel. Le terminal de la provision de pouvoir, mar-
qué du symbol de terre, ( ) doit connecté à un circuit de terre permanent.