Selecting spoke devices, Configuring interfaces for gre over ipsec tunnels – H3C Technologies H3C Intelligent Management Center User Manual
Page 133
123
−
Device Reachability—Select Reachable or Unreachable.
An unselected query condition is not used for device query.
b.
Click Query.
All the devices matching the query conditions are displayed at the upper right of the window.
c.
Select a device in the Devices Found list and click the Add selected icon
to add the device
to the Selected Devices list.
To remove a device from the Selected Devices list, select a device in the Selected Devices list
and click the Remove Selected icon
.
d.
Click OK.
The selected hub device is displayed in Hub Device Information. To replace the hub device,
click the Delete icon to remove the hub device and repeat step 2 or 3 to select a new hub
device.
Selecting spoke devices
1.
Click Select BIMS Spokes.
A window appears for you to select spokes.
2.
Enter query conditions in the Device Name, Serial Number, and Device IP boxes, which support
fuzzy query.
3.
Click Query.
4.
Select spoke devices from the BIMS Device List.
5.
Click OK.
After you add hub and spoke devices, IVM automatically generates unconfigured hub-spoke
tunnels.
To replace a spoke device, click the Select Spokes icon
for that spoke device, and repeat step 2
through 5 to select a new spoke device.
Configuring interfaces for GRE over IPsec tunnels
After you add hub and spoke devices, IVM creates unconfigured tunnels between the hub and the spokes
and displays the tunnels in the Tunnel List.
Tunnel list contents
•
Hub Interface—Interface of the hub that is bound to the IPsec policy or IPsec policy group.
•
Gateway IP—IP address of the hub interface.
•
Spoke Device Name—Name of the spoke.
•
Spoke Interface—Interface of the spoke that is bound to the IPsec policy or IPsec policy group.
•
Gateway IP—IP address of the spoke interface.
•
Configuration—Indicates whether the tunnel has been configured. If the tunnel is unconfigured,
click the Device Parameters icon
icon to enter the tunnel configuration page and complete the
configuration.
To configure interfaces for GRE over IPsec tunnels:
1.
Configure the hub interface:
a.
Select a hub interface from the Hub Interface list.
b.
To modify the name of the hub interface, click the Modify device interface icon
.