Configuring interfaces for gre over ipsec tunnels – H3C Technologies H3C Intelligent Management Center User Manual
Page 92
82
−
Device Label—Enter a device label. You can enter an incomplete label for fuzzy query. For
example, you can enter db to query all devices that have a label containing db.
−
Device Status—Select a status from the list to query devices in that status. The Device Status
list includes Unmanaged, Unknown, Normal, Warning, Minor, Major, and Critical.
−
Device Category—Select a device category.
−
Device Series—Select a device series.
−
Contact—Enter a contact name. You can enter an incomplete name for fuzzy query. For
example, you can enter Bob to query all devices with a contact name containing Bob.
−
Location—Enter a location name. You can enter an incomplete name for fuzzy query. For
example, you can enter Lab to query all devices with a location name containing Lab.
−
Device Reachability—Select Reachable or Unreachable.
An unselected query condition is not used for device query.
b.
Click Query.
All the devices matching the query conditions are displayed at the upper right of the window.
c.
Select devices in the Devices Found list and click the Add selected icon
to add the devices
to the Selected Devices list, or click the Add all icon
to add all devices in the Devices Found
list to the Selected Devices list.
d.
Select devices in the Selected Devices list and click the Remove Selected icon
to remove the
devices from the Selected Devices list, or click the Remove all icon
to remove all devices
from the Selected Devices list.
e.
Click OK.
To replace a spoke device, click the Modify icon
for that spoke device, and repeat step 2 or
3 to select a new spoke device.
Configuring interfaces for GRE over IPsec tunnels
After you add hub and spoke devices, IVM creates unconfigured tunnels between the hub and the spokes
and displays the tunnels in the Tunnel List.
Tunnel list contents
•
Hub Interface—Interface of the hub that is bound to the IPsec policy or IPsec policy group.
•
Gateway IP—IP address of the hub interface.
•
Spoke Device Name—Name of the spoke.
•
Spoke Interface—Interface of the spoke that is bound to the IPsec policy or IPsec policy group.
•
Gateway IP—IP address of the spoke interface.
•
Configuration—Indicates whether the tunnel has been configured. If the tunnel is unconfigured,
click the Device Parameters icon
icon to enter the tunnel configuration page and complete the
configuration.
To configure interfaces for GRE over IPsec tunnels:
1.
Configure the hub interface:
a.
Select a hub interface from the Hub Interface list.
b.
To modify the name of the hub interface, click the Modify device interface icon
.
A window appears.
c.
Enter a new name for the hub interface.