Datum setting – HEIDENHAIN ND 920 User Manual
Page 17
Advertising
17
Datum Setting
1. PROBE POS. X
X
Select X axis (if not already selected).
1. PROBE POS. X
Move the edge finder against workpiece edge
until the LED in the edge finder lights up.
The position of the edge is now displayed.
2. PROBE POS. X
Move the edge finder against workpiece edge
until the LED in the edge finder lights up.
The position of the edge is now displayed.
POS.MEASURED X =
2
6
Enter the position value for the centerline
(for example 26).
SPEC
FCT
Leave the probing functions, or select a new
axis.
ENT
1
2
Advertising