HEIDENHAIN ND 920 - Manual (Page 23)

23
Moving the Axes with Distance-To-Go
NOML. VALUE IY =
0 6 X
ENT
R +
-
Y 3 0
Select the axis, enter the nominal value
as an incremental dimension (for
example 30 mm), select radius
compensation R+ and confirm with ENT.
Move the axis until the display value
is zero
3.
ENT R +
-
NOML. VALUE X =
NOML. VALUE Y =
X 0 3
Select the axis, enter the nominal value
(for example 30 mm), select radius
compensation R– and confirm with ENT.
ENT
Move the axis until the display
value is zero
2.
R +
-
Select the axis, enter the nominal
value (for example 60 mm), select
radius compensation R+ and
confirm with ENT.
Move the axis until the display
value is zero
4.
You can then switch off the distance-
to-go display.
•
•
•