SMA SI 4548-US - Manual (Page 25)

SMA America, LLC 2 Sunny Island 4548-US / 6048-US
Operating Manual SI4548-6048-US-BE-en-20 25
2.4 Required Tools and Materials
The following tools and materials are required in order to mount and install the Sunny Island 4548-US
/ 6048-US:
2.5 Identifying the Sunny Island
Identify the Sunny Island by the serial number (Serial No.) and the device type (Type) on the type
label. The type label is located on the right-hand side of the enclosure. You will require the information
on the type label to use the product safely and when seeking customer support from the
SMA Service Line.
R 1 RS485 Piggy-Back (optional)
S 1 RJ45 cable, white (optional)
Tools (not included in scope of delivery)
Cable knife
Combination pliers
Crimping tool for bootlace ferrules (suitable for wire sizes up to 3/0 AWG)
Diagonal cutting pliers
Drill
Drill bit (e.g. for masonry or wood), fastener
3
/
8
in or Ø 10 mm
Flat-blade screwdriver 2.5 mm
Flat-blade screwdriver SZS 1.0 x 6.5
Allen key, 3 mm to 8 mm
Multimeter
Open-end/box wrenches or socket wrenches in the sizes 10/19/24/30
Cross-head screwdriver, PH1 and PH2
Spirit level
Torque wrench 4 ft-lb to 21 ft-lb (6 Nm to 28 Nm) with hexagon socket screwdriver bit in the sizes
5 mm and 10 mm
Torque wrench 5 in-lb to 22 in-lb (0.56 Nm to 2.5 Nm) with flat-blade screwdriver bit in the sizes
2.5 mm and flat-blade screwdriver SZS 1.0 x 6.5
Insulation stripping tool
Material (not included in scope of delivery)
Cable tie
Heat-shrink tubing
Hexagon screws, 8 mm x 60 mm
Washers
Screw anchor for the wall mounting bracket (e.g. SX 10)
Bootlace ferrules appropriate for the selected cable (see Section 6 "Electrical Connection", page 39)
Position Quantity Designation