Yaskawa JAPMC-CM2304-E - Manual (Page 3)

iii
Using this Manual
This manual describes EtherNet/IP Communication Module 263IF-01 for the MP2000-series Machine Controller.
Read this manual thoroughly before using the 263IF-01. Keep this manual in a safe place for future reference.
„
Basic Terms
Unless otherwise specified, the following definitions are used:
„
Manual Configuration
This manual consists of the chapters listed in the following table. Read the chapters of this manual as required by the
purpose.
„
Graphic Symbols Used in this Manual
The graphic symbols used in this manual indicate the following type of information.
„
Indication of Reverse Signals
In this manual, the names of reverse signals (ones that are valid when low) are written with a forward slash (/) before
the signal name, as shown in the following example:
<Notation Examples>
• MP2000-series Machine Controllers: MP2100M, MP2200, MP2300, MP2310, MP2300S, and MP2500MD
Machine Controllers
• PLC: Programmable Logic Controller
• MPE720: The Programming Device Software or a personal computer running the Programming Device Software
Purpose
Chapter
Selecting
Models and
Peripheral
Devices
Studying
Specifications
and Ratings
Designing
the
System
Panel
Installation
and Wiring
Trial
Operation
Maintenance
and
Inspection
Chapter 1 EtherNet/IP
Communication
9 9
Chapter 2 263IF-01 Module 9 9 9 9 9 9
Chapter 3 Mounting and Starting
the Module
9 9 9 9 9
Chapter 4 EtherNet/IP
Transmission
Definition 9 9 9 9
Chapter 5 Explicit Message and
Explicit Message
Send Function 9 9
Chapter 6 Troubleshooting 9 9 9 9 9
ΠThis symbol is used to indicate important information that should be memorized or minor precautions,
such as precautions that will result in alarms if not heeded.
S-ON = /S-ON
P-CON = /P-CON