TA Triumph-Adler LP 4024 - Manual (Page 132)

Using the Operator Panel
1-117
Automatic Form Feed Timeout Setting
When the printer receives no data for a certain time, it time out and
releases the current interface: it prints whatever data it has in its buffer
and feeds out the page. You can adjust the time-out time as follows:
1
Press the MENU key.
2
Press the or key repeatedly until Others > appears.
3
Press the > key.
4
Press the or key repeatedly until >Form Feed Time appears.
The default setting is 30 seconds.
5
Press the ENTER key. A blinking cursor ( ) appears.
6
Press the or key to increase or decrease the value of the figure
where the cursor is blinking and set the desired time. The time can
be set between 0 and 495 seconds, in 5-second increments. You can
use the > and < keys to move the cursor right and left.
If you want to abandon the setting procedure, press the CANCEL
key.
7
Display the desired time and press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
>Form Feed
Time Out
MENU
Others >
?
>Form Feed
Time Out 030sec.
ENTER >Form Feed Time.
Time Out 030sec.
ENTER
MENU