TA Triumph-Adler LP 4024 - Manual (Page 240)

Glossary
Glossary-2
Cassette mode
This is an operation mode for the MP tray. When
this mode is used, approximately 100 sheets of
plain paper can be fed continuously, the same as
for the cassette.
dpi (dots per inch)
This indicates the number of dots printed per
inch, and is the unit of printer resolution.
Ecoprint
This is a printing mode that controls toner
consumption. Pages printed in the Ecoprint mode
are lighter than pages printed in the normal
mode. The default setting is Off.
Emulation
This refers to emulation of manufacturers'
printers. The printer emulates operation of the
following printers: PCL, Line printer, IBM
Proprinter, DIABLO 630, EPSON LQ-850,
KPDL2.
Expansion memory
This option is used to increase printer memory.
The printer has two expansion sockets, into both
of which you can install a 16 MB, 32 MB, 64 MB,
or 128 MB DIMM (Dual Inline Memory Module).
See your Kyocera Mita dealer to purchase the
DIMM that is best suited for use with this
printer.
Face-up output tray
Tray installed at the rear of the printer. Select
paper output to the face-up output tray when
printing on postcards, envelopes, or labels.
First mode
This is an operation mode for the MP tray.
Because the MP tray default setting is set to first
mode (priority printing from the MP tray), if
there is paper inserted in the MP tray, the first
paper will always feed from there even if another
paper source is selected. First mode is specified
as the factory default, but you can change this
setting from the printer's operator panel.
IEEE1284
This is a standard used when connecting a
printer to a computer, and was established by the
Institute of Electrical and Electronic Engineers
in 1994.
KIR (Kyocera Image Refinement)
This is Kyocera Mita's original smoothing
function. It uses software to enhance the
printer's resolution and produce high-quality
printing. The default setting is Off.
Kyocera Mita Digital Library
This is contained on the CD-ROM supplied with
the printer. The contents of the CD-ROM include
manuals, printer drivers, and various utilities.
Kyocera Mita PrintMonitor
This is a network management tool that can be
used with the Kyocera Mita FS series. You can
view information for printers connected to the
network using SNMP commands. Kyocera Mita
PrintMonitor
is contained on the Kyocera Mita
Digital Library CD-ROM supplied with the
printer.
MB (mega byte)
This unit is used to express data quantities and
memory capacities. 1 MB is equivalent to
1024 kB, or 1,048,576 bytes.