TA Triumph-Adler LP 4024 - Manual (Page 144)

Using the Operator Panel
1-129
7
Press the or key to increase or decrease the value of the figure
where the cursor is blinking and set the desired time. The time must
be set between 000 and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without allowing any
time interval. You can use the > and < keys to move the cursor right
and left.
If you want to abandon the setting procedure, press the CANCEL
key.
8
Display the desired time and press the ENTER key.
9
Press the MENU key. The message display returns to Ready.
ENTER
MENU