TA Triumph-Adler LP 4024 - Manual (Page 52)

Using the Operator Panel
1-37
8
Press the or key to increace or decrease the value of the figure
where the cursor is blinking. It can be set between 0 and 9999 (the
actual maximum effective size is the size of free hard disk space) MB.
You can use the > and < keys to move the cursor right and left.
If you want to abandon the setting procedure, press the CANCEL
key.
The area specified here is the maximum storage area that can be used by
Permanent Code Jobs. Note that the total amount of storage areas
specified must not exceed the total size of the Microdrive. Otherwise, in
the particular storage area, you may only be able to accommodate print
jobs of a smaller amount of print jobs than specified.
9
Display the desired area size and press the ENTER key.
10
Press the MENU key. The message display returns to Ready.
Note
ENTER
MENU