TA Triumph-Adler LP 4024 - Manual (Page 57)

Using the Operator Panel
1-42
Changing Serial Interface Modes
You can set the baud rate, data bits, stop bits, parity, and protocol for the
serial interface.
1
Press the MENU key.
2
Press the or key repeatedly until Interface > appears. One
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option (with the FS-1800N/FS-3800N or when a network interface
card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
If you want to abandon the interface selection procedure, press the
CANCEL
key. The interface remains unchanged.
4
Press the or key repeatedly until Serial appears.
5
Press the ENTER key again.
MENU
ENTER
Interface
? Parallel
Interface
? Serial
ENTER