TA Triumph-Adler LP 4024 - Manual (Page 17)

Understanding the Operator Panel
1-2
1.1 Understanding the Operator Panel
The operator panel has a LCD message display, indicators, and eight keys.
Message Display
The message display gives information in the form of short messages. The
eight messages listed below are displayed during normal warm-up and
printing.
Other messages that may appear when the printer needs the operator's
attention are explained in Chapter 4 .
Interface Indicator
The interface indicator shows the interface that is currently used. It uses
the following abbreviations:
PAR Standard bi-directional parallel interface
SER Serial interface (RS-232C)
OPT Option network interface card
--- No interface is active.
Each interface has a timeout time of 30 seconds during which the other
interface should wait to receive a print job. Even a print job has been
complete on the interface, you should wait for this period until the other
interface begins printing the job.
Message Meaning
Self test The printer is self-testing after power-up.
Please wait The printer is warming up and is not ready. When
the printer is switched on for the first time after the
toner container is installed, (Adding toner)
also appears.
Ready The printer is ready to print.
Processing The printer is receiving data, generating graphics,
reading a CompactFlash card/Microdrive, or
printing.
Sleeping The printer is in Sleep mode. The printer wakes
from Sleep mode whenever a key on the operator
panel is pressed, the cover is opened or closed, or
data is received. The printer then warms up and
goes online. The time that the printer takes to enter
Sleep mode depends on the Sleep Timer setting.
Cancelling data Jobs inside the printer are being canceled. To cancel
a job, see the table on page
1-5 .
Waiting The printer is waiting for the end-of-job command
before printing the last page. Pressing the GO key
allows you to obtain the last page immediately.
FormFeed Time Out The printer is printing the last page after a waiting
period.
INTERFACE
Note