ProSoft Technology MVI56E-MNETR User Manual
Page 22
MVI56E-MNETR ♦ ControlLogix Platform
Start Here
Modbus TCP/IP Interface Module with Reduced Data Block
User Manual
Page 22 of 153
ProSoft Technology, Inc.
August 31, 2009
2 Click CIP
P
ATH
E
DIT
to open the
CIP
CONNECT
P
ATH
E
DITOR
dialog box.
The CIP
CONNECT
P
ATH
E
DITOR
allows you to define the path between the PC
and the MVI56E-MNETR module. The first connection from the PC is always a
1756-ENBT (Ethernet/IP) module.
Each row corresponds to a physical rack in the CIP path.
If the MVI56E-MNETR module is located in the same rack as the first 1756-
ENBT module, select
R
ACK
N
O
.
1 and configure the associated parameters.
If the MVI56E-MNETR is available in a remote rack (accessible through
ControlNet or Ethernet/IP), include all racks (by using the A
DD
R
ACK
button).
Parameter Description
Source Module
Source module type. This field is automatically selected
depending on the destination module of the last rack (1756-
CNB or 1756-ENBT).
Source Module IP Address
IP address of the source module (only applicable for 1756-
ENBT)
Source Module Node Address
Node address of the source module (only applicable for 1756-
CNB)
Destination Module
Select the destination module associated to the source module
in the rack. The connection between the source and destination
modules is performed through the backplane.
Destination Module Slot Number
The slot number where the destination MVI56E module is
located.