Configuration error word – ProSoft Technology MVI56E-MNETR User Manual
Page 98
MVI56E-MNETR ♦ ControlLogix Platform
Diagnostics and Troubleshooting
Modbus TCP/IP Interface Module with Reduced Data Block
User Manual
Page 98 of 153
ProSoft Technology, Inc.
August 31, 2009
Operation Messages
After the initialization step, the following message pattern will be repeated.
<Backplane Status> <IP Address> <Backplane Status> <Port Status>
Code Message
<Backplane Status>
OK: Module is communicating with processor
ERR: Module is unable to communicate with processor. For
this scenario, the <Port Status> message above is replaced
with "Processor faulted or is in program mode".
<IP Address>
Module IP address
<C0>
OK: Port is communicating without error
Communication Errors: port is having communication errors.
Refer to PCB diagnostics for further information about the
error.
The LEDs indicate the module's operating status as follows:
Module Color
Status
Indication
On
The MVI56E-MNETR is working normally.
APP Amber
Off
The MVI56E-MNETR module program has recognized a
communication error on its Application Port(s).
Off
The card is not receiving adequate power, or is not securely
plugged into the rack.
Green
The module is operating normally.
OK
Red/
Green
Red
The module has detected an internal error, or is being
initialized. If the LED remains red for over 10 seconds, the
module is not working. Remove it from the rack and re-insert it
to restart its internal program.
Off
The battery voltage is OK and functioning.
BAT Red
On
The battery voltage is low, or battery is not present. Allow
battery to charge by keeping module plugged into rack for 24
hours. If BAT LED still does not go off, contact ProSoft
Technology, as this is not a user-serviceable item.
4.9.1 Configuration
Error
Word
If a configuration error is found for the Client, the Client configuration error word
will have a value other than zero. The configuration error word bits have the
following definitions:
Bit Description
Value
0
0x0001
1
0x0002
2
0x0004
3
0x0008
4
Invalid retry count parameter
0x0010
5
The float flag parameter is not valid.
0x0020
6
The float start parameter is not valid.
0x0040
7
The float offset parameter is not valid.
0x0080