HP 2/8q Fibre Channel - Manual (Page 101)

Switch Manager
101 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Port Properties dialog box messages
Table 32: Port Properties dialog box messages
Message User action
Invalid value entered for interop credits.
or
Failed to set I/O stream guard change.
or
Failed to set new interop credits.
or
Request to save and activate config failed.
or
Received error in attempting to edit switch
configuration.
or
Received error in attempting to save switch
configuration.
or
Received error in attempting to activate switch
configuration.
Verify that the data is valid, that the user has
permissions to modify the configuration on the
switch, that the switch is reachable in the
fabric, and that the fabric is reachable from
the user’s workstation, and then retry the
configuration change. Interop Credits is not
supported at this time.
Received error in attempting to release admin
privileges.
The application did not receive a required
response from the switch. This may be caused
by a momentary or extended loss of
communications with the fabric.
First refresh the information in the display to
determine whether the changes took effect. If
not, retry the changes.
If the error persists, determine whether
communications with the switch have stopped,
and resolve any network problems. When
communication with the fabric has resumed,
return to the application to view the properties
for the port and verify whether the changes
took effect. If not, retry the changes.
Request to save and activate config failed. Verify that the data is valid, that the user has
permissions to modify the configuration on the
switch, that the switch is reachable in the
fabric, and that the fabric is reachable from
the user’s workstation, and then retry the
configuration change.