HP 2/8q Fibre Channel - Manual (Page 123)

Command Line Interface
123 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Remote system type is UNIX.
Using binary mode to transfer files.
221-You have transferred 43430 bytes in 1 files.
221-Total traffic for this session was 43888 bytes in 1 transfers.
221 Thank you for using the FTP service on localhost.localdomain.
FTP the dump support file to another machine? (y/n): n
Date
command
This command displays or sets the system date and time. To set the date and time the
information string must be provided in this format:
MMDDhhmmCCYY . The new date and time
takes effect immediately.
Authority
Admin session, except to display the date.
Syntax
DATE
Keywords
[MMDDhhmmCCYY]
Specifies the date—this requires an admin session. If you omit [MMDDhhmmCCYY] ,
the current date is displayed, which does not require an admin session.
Examples
2/8q FC Switch #> date
Mon Apr 07 07:51:24 2003
Firmware Install
command
Downloads firmware from a remote host to the switch, installs the firmware, and then resets
the switch (without a power-on self test) to activate the firmware. If possible, a non-disruptive
firmware activation is performed. The command prompts you for the IP address of the remote
host, an account name and password on the remote host, and a pathname for the firmware
image file.
Authority
Admin
Syntax
FIRMWARE INSTALL