HP 2/8q Fibre Channel - Manual (Page 139)

Command Line Interface
139 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
SWITCH
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value. For
each parameter, enter a new value or press Enter to accept the current value shown in
brackets.
Table 52 describes the Set Config Switch parameters.
NoClose Loop circuit closure prevention. Enables (True) or disables
(False) the loop’s ability to remain in the open state
indefinitely. True reduces the amount of arbitration on a loop
when there is only one device on the loop. The default is
False.
IOStreamGuard I/O Stream Guard. Enable (Enable) or disables (Disable) the
suppression of RSCN messages. I/O Stream Guard should be
enabled only for ports connected to initiator devices. The
default is Disable.
VIEnable Enables (True) or disables (False) VI preference routing. The
default is False. Enabling VIEnable will disable MFSEnable.
PDISCPingEnable Enables (True) or disables (False) the transmission of ping
messages from the switch to all devices on a loop port. The
default is True.
Table 52: Set config switch parameters
Parameter Description
AdminState Switch administrative state: online, offline, or diagnostics. The
default is Online.
BroadcastEnabled Broadcast. Enables (True) or disables (False) forwarding of
broadcast frames. The default is True.
DefaultDomainID Default domain ID. The default is 1.
DomainIDLock Prevents (True) or allows (False) dynamic reassignment of the
domain ID. The default is False.
SymbolicName Descriptive name for the switch. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is 2/8q FC Switch.
R_A_TOV Resource Allocation Timeout Value. The number of
milliseconds the switch waits to allow two ports to allocate
enough resources to establish a link. The default is 10000.
E_D_TOV Error Detect Timeout Value. The number of milliseconds a port
is to wait for errors to clear. The default is 2000.
PrincipalPriority The priority used in the FC-SW-2 principal switch selection
algorithm. 1 is high, 255 is low. The default is 254.
ConfigDescription Switch configuration description. The configuration description
can be up to 32 characters excluding #, semicolon (;), and
comma (,). The default is 2/8q FC Switch.
InteropMode Propagates just the active zone set throughout the fabric (True,
compliant) or the entire zoning database (False,
non-compliant). The default is True. (not supported)
LegacyAddressFormat Available only when the InteropMode parameter is False, this
parameter enables (True) or disables (False) the use of legacy
address formatting for interoperating with non-FC-SW-2
switches. See Table 52 . The default is False. (not supported)
Table 51: Set Config port parameters (Continued)
Parameter Description