HP 2/8q Fibre Channel - Manual (Page 142)

Command Line Interface
142 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
ExtCredit (dec value, increments of 15, non-loop only) [0 ]
FANEnable (True / False) [True ]
LCFEnable (True / False) [False ]
MFSEnable (True / False) [False ]
MSEnable (True / False) [True ]
NoClose (True / False) [False ]
IOStreamGuard (Enable / Disable) [Disable]
VIEnable (True / False) [False ]
PDISCPingEnable (True / False) [True ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
2/8q FC Switch (admin-config) #>
The following is an example of the SET CONFIG SWITCH command:
2/8q FC Switch #> admin start
2/8q FC Switch (admin) #> config edit
2/8q FC Switch (admin-config) #> set config switch
A list of attributes with formatting and default values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the
list
press 'q' or 'Q' and the ENTER key to do so.
AdminState (1=Online, 2=Offline, 3=Diagnostics) [Online ]
BroadcastEnable (True / False) [False ]
InbandEnabled (True / False) [False ]
DefaultDomainID (decimal value, 1-239) [11 ]
DomainIDLock (True / False) [True ]
SymbolicName (string, max=32 chars) [2/8q FC Switch]
R_A_TOV (decimal value, 100-100000 msec) [10000 ]
E_D_TOV (decimal value, 10-20000 msec) [2000 ]
PrincipalPriority (decimal value, 1-255) [254 ]
ConfigDescription (string, max=32 chars) [
2/8q FC Switch
]
InteropMode (True / False) [True ]