HP 2/8q Fibre Channel User Manual
Page 151
Command Line Interface
151
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
alarm [option]
Displays the alarm log and session display setting. If you omit [option], the command
displays the last 200 alarm entries. The alarm log is cleared when the switch is reset or
power cycled. [option] has the following value:
setting
—Displays the status of the parameter that controls the display of alarms in
the session output stream. This parameter is set using the
Set Alarm
command.
broadcast
Displays the broadcast tree information and all ports that are currently transmitting
and receiving broadcast frames.
chassis
Displays chassis component status and temperature.
config [option]
Displays switch, port, and zoning configuration attributes. See the “
domains
Displays list of each domain and its worldwide name in the fabric.
donor
Displays list of current donor configuration for all ports.
fabric
Displays list of each domain, symbolic name, worldwide name, node IP address, and
port IP address.
interface
Displays the status of the active network interfaces.
log [option]
Displays log entries. See the “
” on page 163. The log is cleared
when the switch is reset or power cycled.
lsdb
Displays Link State database information.
mem [count]
Displays information about memory activity for the number of seconds given by
[count]. If you omit [count], the value 1 is used. Displayed memory values are in 1K
block units.
Note:
This keyword will display memory activity updates until [count] is reached – it cannot be
interrupted. Therefore, avoid using large values for [count].
ns [option]
Displays name server information for the specified [option]. If you omit [option],
name server information for the local domain ID is displayed. [option] can have the
following values:
all
—Displays name server information for all switches and ports.
[
domain_id
]—Displays name server information for the switch given by
[domain_id]. [domain_id] is a switch domain ID.