HP 2/8q Fibre Channel - Manual (Page 137)

Command Line Interface
137 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Set Config
command
Sets switch, port, port threshold alarm, and zoning configuration parameters. The changes you
make with this command are not retained when you reset or power cycle the switch unless you
save them using the
Config Save command. See the “ Config command ” on page 119.
Authority
Admin and Config Edit
Syntax
SET CONFIG
Keywords
PORT [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a new
value or press Enter to accept the current value shown in brackets. Enter
q to end the
configuration for one port, or qq to end the configuration for all ports. Table 51
describes the port parameters.
PORTS [port_number]
Initiates an editing session in which to change configuration parameters for all ports
based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press Enter to
accept the current value shown in brackets. Enter
q to end the configuration. Table 51
describes the port parameters.