38 default graph options dialog box, Figure 38 – HP 2/8q Fibre Channel User Manual
Page 95
Switch Manager
95
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Figure 38: Default Graph Options dialog box
You can also right-click on a graph, and then select Change Graph Options.
1. Choose the units for the graph:
— Select the Show Bytes Data on Graph check box to plot data in KBytes/second.
— Select the Show Frames Data on Graph check box to plot data in frames/second.
2. Choose what data type to plot. For example, if you selected Show Frames Data on
Graph in
step 1
, you can plot one or all of the following:
— Total frames transmitted and received (Total Frames)
— Total frames transmitted (Total Tx Frames)
— Total frames received (Total Rx Frames)
Note:
In addition to these, you can also plot total errors by selecting the Total Errors check box.
3. Select Display Grid on Graph to display the unit grid.
4. Choose the color scheme for the graph:
a.
Click Select Color to open its corresponding Select Color dialog box.
b.
Select the color for each data type, the unit grid, and the background by clicking the
corresponding color box or button.
In each case, you can choose a color using the Swatches, Red-Green-Blue (RGB), or
Hue-Saturation-Brightness (HSB) method.