HP 2/8q Fibre Channel - Manual (Page 136)

Command Line Interface
136 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
CONFIG [option]
Sets switch, port, port threshold alarm, and zoning configuration parameters. See the
“
Set Config command ” on page 137.
LOG [option]
Specifies the type of entries to be entered in the event log. See the “ Set Log
Command ” on page 144.
PAGEBREAK [state]
Specifies how much information is displayed on the screen at a time according to the
value given by [state]. This keyword does not require an admin session. [state] can be
one of the following:
ON —Limits the display of information to 20 lines at a time. The page break functions
affects the following commands: Alias (List, Members), Show (Alarm,
Log), Zone (List, Members), Zoneset (List, Zones), Zoning
(Active, List)
.
OFF —Allows continuous display of information without a break.
PORT [option]
Sets port state and speed for the specified port. The previous Set Config Port settings
are restored after a switch reset or a reactivation of a switch configuration. See the
“
Set Port command ” on page 146.
SETUP [option]
Changes SNMP and system configuration settings. See the “ Set Setup command ” on
page 147.
SWITCH [state]
Changes the administrative state for all ports on the switch to the state given by [state].
The previous Set Config Switch settings are restored after a switch reset or a
reactivation of a switch configuration. [state] can be one of the following:
ONLINE —Places all ports online
OFFLINE —Places all ports offline.
DIAGNOSTICS —Prepares all ports for testing.
Examples
2/8q FC Switch #> set beacon on
2/8q FC Switch $> set beacon off