HP 2/8q Fibre Channel - Manual (Page 146)

Command Line Interface
146 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
SAVE
Saves the log settings for the component, severity level, port, and display level. These
settings remain in effect after a switch reset. The log settings can be viewed using the
Show Log Settings command. To export log entries to a file, use the S et Log
Archive command.
START
Starts the logging of events based on the Port, Component, and Level keywords
assigned to the current configuration. The logging continues until you enter the
Set
Log Stop command.
STOP
Stops logging of events.
Notes
In addition to critical, warn, and informative severity levels, the highest event severity
level is alarm. The alarm level describes events that are disruptive to the administration or
operation of a fabric and require administrator intervention. Alarms are always logged and
always displayed on the screen.
Set Port
command
Sets port state and speed for the specified port temporarily until the next switch reset or new
configuration activation. This command also clears port counters.
Authority
Admin, except for the Clear keyword
Syntax
SET PORT [PORT_NUMBER}
Keywords
[PORT_NUMBER]
Specifies the port. Ports are numbered beginning with 0.
BYPASS [ALPHA]
Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address
(ALPA) or to all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the
keyword ALL to choose all ALPAs.
CLEAR
Clears the counters on the port. This keyword does not require an admin session.
ENABLE
Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.
SPEED [TRANSMISSION_SPEED]
Specifies the transmission speed for the specified port. Choose one of the following
port speed values:
2Gb/s —Two gigabits per second.
Auto —The port speed is automatically detected.