HP 2/8q Fibre Channel - Manual (Page 76)

Switch Manager
76 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Figure 28: Restore dialog boxes – Full and Selective
3. Enter the archive file name or browse for the file. This archive file must be one that was
produced by the Switch Manager Archive function. Configuration backup files created
with the Config Backup CLI command are not compatible with the Switch Manager
Restore function.
4. To restore all configuration settings, click the Full Restore tab, and then click Restore.
To restore selected configuration settings, click the Selective Restore tab and check one
or more of the following boxes, and then click Restore:
— Network Properties—Restores all settings presented in the Network Properties
dialog box except the IP address. Refer to“ Network properties ” on page 72.
— IP Address—Restores switch IP address in addition to the other network properties.
— Switch Properties: Restores all settings presented in the Switch Properties dialog box
except the domain ID. Refer to“ Switch properties ” on page 69.
— Domain ID—Restores switch domain ID in addition to the other switch properties.
— Port Properties—Restores all settings presented in the Port Properties dialog box.
Refer to“ Configuring ports ” on page 85.
— Configured Zoning—Restores all zone sets, zones, and aliases in the switches zoning
database.
5. If you select the Configured Zoning or Full Restore option and the file contains zone
sets, a dialog box prompts you to activate one of those zone sets.
6. Click Yes.
7. Select a zone set from the drop-down list in the Select Zone Set to be Activated dialog
box.
8. Click OK and view the results in the top pane of the Restore dialog box.