HP 2/8q Fibre Channel - Manual (Page 135)

Command Line Interface
135 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Set
command
Sets a variety of switch parameters.
Authority
Admin for all keywords except Alarm , Beacon , and Pagebreak .
Syntax
SET
Keywords
ALARM [option]
Controls the display of alarms in the session output stream or clears the alarm log.
[option] can be one of the following:
CLEAR —Clears the alarm log history. This value requires an Admin session.
ON —Enables the display of alarms in the session output stream.
OFF —Disables the display of alarms in the session output stream.
BEACON [state]
Enables or disables the flashing of the Logged-In LEDs according to [state]. This
keyword does not require an admin session. [state] can be one of the following:
ON —Enables the flashing beacon.
OFF —Disables the flashing beacon.
Object ID 1.3.6.1.4.1.1663.1.1.1.1.31
AuthFailureTrap False
ProxyEnabled True
Table 50: System configuration default settings
Parameter Default setting
Ethernet Network Discovery Static
Ethernet Network IP Address 10.0.0.1
Ethernet Network IP Mask 255.0.0.0
Ethernet Gateway Address 10.0.0.254
Admin Timeout 30 minutes
LocalLogEnabled True
RemotelogEnabled False
RemoteLogHostAddress 10.0.0.254
NTPClientEnabled False
NTPServerAddress 10.0.0.254
Table 49: SNMP configuration default settings (Continued)
Parameter Default setting