11 transmit control register (tcr), 11transmit control register (tcr) -17 – Motorola ColdFire MCF5281 User Manual
Page 327
Fast Ethernet Controller (FEC)
Freescale Semiconductor
17-17
17.4.11 Transmit Control Register (TCR)
TCR is read/write and configures the transmit block. This register is cleared at system reset. Bits 2 and 1
must be modified only when ECR[ETHER_EN] is cleared.
IPSBAR
Offset:
0x1084
Access: User read/write
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
R
0
0
0
0
0
MAX_FL
W
Reset
0
0
0
0
0
1
0
1
1
1
1
0
1
1
1
0
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
R
0
0
0
0
0
0
0
0
0
0
FCE
BC_
REJ
PROM
MII_
MODE
DRT LOOP
W
Reset
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
1
Figure 17-10. Receive Control Register (RCR)
Table 17-14. RCR Field Descriptions
Field
Description
31–27
Reserved, must be cleared.
26–16
MAX_FL
Maximum frame length. Resets to decimal 1518. Length is measured starting at DA and includes the CRC at the
end of the frame. Transmit frames longer than MAX_FL causes the BABT interrupt to occur. Receive frames longer
than MAX_FL causes the BABR interrupt to occur and sets the LG bit in the end of frame receive buffer descriptor.
The recommended default value to be programmed is 1518 or 1522 if VLAN tags are supported.
15–6
Reserved, must be cleared.
5
FCE
Flow control enable. If asserted, the receiver detects PAUSE frames. Upon PAUSE frame detection, the transmitter
stops transmitting data frames for a given duration.
4
BC_REJ
Broadcast frame reject. If asserted, frames with DA (destination address) equal to FFFF_FFFF_FFFF are rejected
unless the PROM bit is set. If BC_REJ and PROM are set, frames with broadcast DA are accepted and the M
(MISS) is set in the receive buffer descriptor.
3
PROM
Promiscuous mode. All frames are accepted regardless of address matching.
2
MII_MODE
Media independent interface mode. Selects the external interface mode for transmit and receive blocks.
0 7-wire mode (used only for serial 10 Mbps)
1 MII mode
1
DRT
Disable receive on transmit.
0 Receive path operates independently of transmit (use for full duplex or to monitor transmit activity in half duplex
mode).
1 Disable reception of frames while transmitting (normally used for half duplex mode).
0
LOOP
Internal loopback. If set, transmitted frames are looped back internal to the device and transmit output signals are
not asserted. The internal bus clock substitutes for the FEC_TXCLK when LOOP is asserted. DRT must be set to
0 when setting LOOP.
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3