MITSUBISHI ELECTRIC Merservo MR-J2S- B - Manual (Page 197)

12 - 38
12. OPTIONS AND AUXILIARY EQUIPMENT
(2) System configuration
(a) Components
To use this software, the following components are required in addition to the servo amplifier and
servo motor.
Model (Note 1) Description
(Note 2)
Personal
computer
IBM PC-AT compatible where the English version of Windows ® 95, Windows ® 98, Windows ® Me,
Windows NT ® Workstation 4.0, Windows ® 2000 Professional, Windows ® XP Professional and Windows ®
XP Home Edition operates
Processor: Pentium ® 133MHz or more (Windows ® 95, Windows ® 98, Windows NT ® Workstation 4.0,
Windows ® 2000 Professional)
Pentium ® 150MHz or more (Windows ® Me)
Pentium ® 300MHz or more (Windows ® XP Professional, Windows ® XP Home Edition)
Memory:16MB or more (Windows ® 95)
24MB or more (Windows ® 98)
32MB or more (Windows ® Me, Windows NT ® Workstation 4.0, Windows ® 2000 Professional)
128MB or more (Windows ® XP Professional, Windows ® XP Home Edition)
Free hard disk space: 60MB or more
Serial port used
OS
Windows ® 95, Windows ® 98, Windows ® Me, Windows NT ® Workstation 4.0, Windows ® 2000 Professional
(English version)
Display
One whose resolution is 800 600 or more and that can provide a high color (16 bit) display.
Connectable with the above personal computer.
Keyboard Connectable with the above personal computer.
Mouse Connectable with the above personal computer. Note that a serial mouse is not used.
Printer Connectable with the above personal computer.
Communication
cable
MR-CPCATCBL3M
When this cannot be used, refer to section 12.1.5 (3) and fabricate.
Note 1. Windows and Windows NT are the registered trademarks of Microsoft Corporation in the United State and other countries.
Pentium is the registered trademarks of Intel Corporation.
2. On some personal computers, this software may not run properly.
(b) Configuration diagram
CN3 CN2
Personal computer
To RS-232C
connector
Communication cable
Servo amplifier
Servo motor