MITSUBISHI ELECTRIC Merservo MR-J2S- B - Manual (Page 27)

1 - 10
1. FUNCTIONS AND CONFIGURATION
(2) MR-J2S-200B MR-J2S-350B
POINT
The servo amplifier is shown without the front cover. For removal of the
front cover, refer to section 1.7.2.
Reference
Section 13.3
Chapter 4
Name/Application
Battery holder
Contains the battery for absolute position data backup.
Battery connector (CON1)
Used to connect the battery for absolute position data
backup.
Display
The two-digit, seven-segment LED shows the servo
status and alarm number.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Used to connect the servo motor encoder.
Main circuit terminal block (TE1)
Used to connect the input power supply and servo
motor.
Protective earth (PE) terminal ( )
Ground terminal.
Section 13.3
Axis select switch (SW1)
Section 3.11
Section 3.2
Section 3.2
Section 3.2
Section 12.1.5
Section 1.5
Section 3.2
Section 12.1.5
Control circuit terminal block (TE2)
Used to connect the control circuit power supply and
regenerative option.
Section 3.5.2
Section 10.1
Section 3.5.2
Section 10.1
Section 12.1.1
Section 3.8
Section 10.1
Cooling fan
Fixed part
(4 places)
A
B
C
D
EF 01
2 3
4
5 6 7 8 9
1
C
B
9 8 7
5
4
3
0 F
D
SW1
Bus cable connector (CN1A)
Used to connect the servo system controller or
preceding axis servo amplifier.
Communication connector (CN3)
Used to connect a personal computer (RS-232C) or
output analog monitor data.
Bus cable connector (CN1B)
Used to connect the subsequent axis servo amplifier
or termination connector (MR-A-TM).
Used to set the axis number of
the servo amplifier.
Rating plate