MITSUBISHI ELECTRIC Merservo MR-J2S- B - Manual (Page 103)

5 - 14
5. PARAMETERS
Classifi-
cation
No. Symbol Name and Function
Initial
Value
Unit
Setting
Range
62 0000
63 400
64 100
65 1
66 1
67 0
68 0
69 0
70 0
71 0
72 0
73 0
74 0
E
xpa
n
si
on
pa
ra
m
et
er 2
75
For manufacturer setting
Do not change this value by any means.
0
5.3 Analog monitor
The servo status can be output to two channels in terms of voltage. The servo status can be monitored
using an ammeter.
(1) Setting
Change the following digits of parameter No. 22.
Analog monitor 2(MO2) output selection
(Signal output to across MO2-LG)
Analog monitor 1(MO1) output selection
(Signal output to across MO1-LG)
Parameter No. 22
0 0
Parameters No. 27 and 28 can be used to set the offset voltages to the analog output voltages. The
setting range is between 999 and 999mV.
Parameter No. Description Setting range [mV]
27 Used to set the offset voltage for the analog monitor 1(MO) output.
28 Used to set the offset voltage for the analog monitor 2(MO2) output.
999 to 999