MITSUBISHI ELECTRIC Merservo MR-J2S- B - Manual (Page 61)

3 - 18
3. SIGNALS AND WIRING
3.6 Connection of servo amplifier and servo motor
3.6.1 Connection instructions
WARNING
Insulate the connections of the power supply terminals to prevent an electric
shock.
CAUTION
Connect the wires to the correct phase terminals (U, V, W) of the servo amplifier
and servo motor. Otherwise, the servo motor will operate improperly.
Do not connect AC power supply directly to the servo motor. Otherwise, a fault
may occur.
POINT
Do not apply the test lead bars or like of a tester directly to the pins of the
connectors supplied with the servo motor. Doing so will deform the pins,
causing poor contact.
The connection method differs according to the series and capacity of the servo motor and whether or not
the servo motor has the electromagnetic brake. Perform wiring in accordance with this section.
(1) For grounding, connect the earth cable of the servo motor to the protective earth (PE) terminal ( ) of
the servo amplifier and connect the ground cable of the servo amplifier to the earth via the protective
earth of the control box. Do not connect them directly to the protective earth of the control panel.
Servo
amplifier Servo motor
PE terminal
Control box
(2) Do not share the 24VDC interface power supply between the interface and electromagnetic brake.
Always use the power supply designed exclusively for the electromagnetic brake.
3.6.2 Connection diagram
CAUTION
During power-on, do not open or close the motor power line. Otherwise, a
malfunction or faulty may occur.
POINT
For the connection diagram of the MR-J2S-11KB to MR-J2S-22KB, refer
to section 3.12 where the connection diagram is shown together with the
power line circuit.
The following table lists wiring methods according to the servo motor types. Use the connection diagram
which conforms to the servo motor used. For cables required for wiring, refer to section 12.2.1. For
encoder cable connection, refer to section 12.1.4. For the signal layouts of the connectors, refer to section
3.6.3.
For the servo motor connector, refer to chapter 3 of the Servo Motor Instruction Manual.