Mitel SX-2000 - Manual (Page 106)

SX-200 General Information Guide
92 Revision A 50003510
DATASET 2100 series supports asynchronous data communications from 110 bps to19.2 kbps,
and synchronous data communications at rates from 1200 bps to19.2 kbps. In asynchronous
mode these datasets have the same operating characteristics as the DATASET 1100 series.
In synchronous mode, the DATASET 2100 series uses X.31 protocol.
The DATASET 1100 series is available as
• DATASET 1103 Standalone.
The DATASET 2100 series is available as
• DATASET 2103 Standalone.
The DATASET 1100 and 2100 series of datasets interface to a PBX DNIC circuit through a
single pair.
The MILINK Data Module is a limited distance, asynchronous, digital dataset. It converts data
signals from such RS-232 serial devices as computers or display terminals, to high-speed digital
signals. This conversion allows for peripheral interface with the SX-200 EL and SX-200 ML
systems.
The MILINK Data Module is a desktop unit which can be positioned under or beside a
SUPERSET 410, SUPERSET 420 or SUPERSET 430 telephone and connected to a modular
jack at the base of the telephone. The 2-pair cable that connects the SUPERSET telephone to
the switch, carries both voice and data signals, allowing the use of an RS-232 device and the
SUPERSET telephone simultaneously.
DATASET 1103 Standalone
The standalone DATASET 1103 is packaged in a flat case which can be placed under a standard
desk telephone set. It is used to interface a terminal, personal computer, or other peripheral
device for connection to a host computer.
DATASET 1103 - Typical Application