StorageTek 9840 - Manual (Page 125)

95741 Sixth Edition 5-9
Operator Panel
CSL Switches
Refer to Table 5-4 for CSL operator panel switch descriptions.
Note: Refer to “Operator Panels” on page 1-7 for explanation of the 9840 Tape
Drive switches.
Table 5-4. CSL Operator Panel Switches
Switch Description
Start Switch
(CSL only)
Pressing this switch restarts CSL operation after the operator empties a
full output bin or replenishes an empty input bin.
Also used to restart CSL operation after clearing a misfed cartridge.
Notes:
1. Remove the cartridge before pressing the Start switch.
2. Press the Start switch twice when there is a load failure or
solid operator indicator (red) on the CSL. Pressing the switch
twice re initializes the CSL.
Autoload Mode
Switch
(CSL only)
Pressing this switch changes the operation of the CSL to one of three
modes: System, Automatic, or Manual.
Notes:
1. Select the mode of operation by using the Autoload Mode
switch.
2. Press the Start switch to set the mode of operation.
The CSL powers on in the default mode selected in the drive
configuration menu. The default mode is overridden when the switch is
used to select a new setting. The CSL remains in the selected mode
while the drive is powered on. This does not change the IPL default
mode in the drive configuration menu.
• System allows host to control CSL.
• Auto allows CSL to operate automatically.
• Manual allows manual operations only.