StorageTek 9840 - Manual (Page 78)

Rack
3-28 Sixth Edition 95741
CAUTION:
Equipment damage. Do not attempt to move the rack once drive or CSL
trays are installed. To prevent damage to the rack, you must remove all
drive/CSL trays and the stabilizer before relocating the rack.
Tools Required
The following tools are required to complete this installation:
• 1/2 in. open-end wrench
• 3/4 in. open-end wrench
• Assorted Torx screwdrivers
• Bubble level
Install Stabilizer
Use the instructions below to install the stabilizer plate on the rack:
1. Use a 3/4 in. wrench to lower the rack leveling pads, and while adjusting the pads use a
bubble level to verify the rack is plum and level.
2. Use a 1/2 in. wrench to install the stabilizer on the front of the rack.
Note: The stabilizer must remain connected to the rack. It should only be removed
when you are relocating the rack.
1. Stabilizer
2. Mounting screw (4X)
3. Leveling pad
C53255
1
3
2