StorageTek 9840 - Manual (Page 69)

95741 Sixth Edition 3-19
Desktop Units
■
Desktop Units
This section provides the installation procedure for the 9840 Tape Drive
desktop configuration. A desktop configuration contains either a manual mount
drive or a CSL. Fibre Channel or SCSI interfaces are available.
This section contains the following desktop procedures:
• “Desktop Drive Shipping Insert”
• “CSL Shipping Insert” on page 3-20
• “Install Host Interface Cables” on page 3-21
• “Power-On Desktop/CSL” on page 3-25
Desktop Drive Shipping Insert
Use the instructions below to remove the shipping insert from the drive:
Note: See “CSL Shipping Insert” on page 3-20 to remove the CSL shipping
insert.
1. Remove the shipping insert from the drive.
a. Squeeze both sides of the handle together.
b. Pull the shipping insert out from the drive.
1. Shipping insert
2. Store the shipping insert.
Note: The shipping insert should be installed in the drive whenever the Desktop Unit is
returned to StorageTek for any reason.
C53520
1