StorageTek 9840 - Manual (Page 183)

95741 Sixth Edition 6-27
SCSI Change Configuration Menu
Data Security Erase Mode Submenu
Full DSE Y
Full DSE N
Defaults to last saved selection.
Full DSE Y writes a random
binary pattern on the media,
over-writing existing data, from
the point of an “Erase” command,
to the End of Tape.
Full DSE N writes data on the
media that indicates valid data
does not exist beyond the point
of an “Erase” command.
1. Press Menu to bypass, or
2. Press Select to toggle option;
then, press Menu to set, and
advance to next submenu.
Note: Manufacturing ships drive with the Full DSE Y option selected.
SCSI ID Submenu
SCSI ID x Defaults to last saved selection.
Pressing Select when the x
character is steady, starts the
change mode. The
X character
begins flashing and will
increment up, one value with
each additional press of
Select.
Pressing Menu sets flashing
character at displayed value.
Establishes the SCSI ID of the
drive. The value range 0–7 is for
narrow (8bit) bus width, and
0–F is for wide (16bit) bus width.
1. Press Select to start change mode;
or, press Menu to bypass.
2. Press Select to increment
until desired value is displayed,
then press
Menu to set.
3. Press Menu to advance to the next
submenu; or, press Select to
restart change mode.
Note: Manufacturing ships drive with the SCSI ID 6 address option selected.
SCSI Target Negotiation Mode Submenu
Targ Neg Y
Targ Neg N
Defaults to last saved selection.
When Yes is selected, it allows
the drive control unit to initiate
negotiations with the host to
clarify the SCSI transmission
speed, in case the host had not
done so.
1. Press Menu to bypass, or
2. Press Select to toggle option;
then, press Menu to set, and
advance to next submenu.
Note: Manufacturing ships drive with the Targ Neg N option selected.
Table 6-2. Menu Table—SCSI Configuration (Continued)
Options Notes Procedure