StorageTek 9840 - Manual (Page 201)

95741 Sixth Edition 7-5
Dislodge a Stuck Tape
CodUpFail3 The tape format is
unreadable. Reclaim as a data tape, recreate code tape.
Retry the operation.
Try another tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
CodUpFail4 This is not a code-update
tape. Retry with the correct tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
DatCrFail1 Unable to create (format) a
data tape. Make sure the tape is write-enabled.
Try another drive or CSL.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
DmpCrFail1 Unable to create (format) a
dump tape. Make sure the tape is write-enabled.
Try another tape.
Try another drive or CSL.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
DmpCrFail2 The tape format is
unreadable. Reclaim as a data tape.
Retry the operation.
Try another tape.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
DumpToHost The dump or event log is
being transferred to host; the
operator panel switches are
locked No action necessary.
DmpWrFail1 Unable to write a dump to
tape.
Unable to position on tape.
Try another tape.
Make sure the tape is formatted for a
dump.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
DmpWrFail2 No dump to process. Force a diagnostic dump.
Note: In code level 1.30.109 and up, error message is replaced by CHK xxxx .
DumpAgain? The drive or CSL detected the
same “CHK (xxxx)” within
one minute. Go to “DumpAgain? Indication” on
page 7-12 .
Exp ClCart The cleaning cartridge is used
up. Replace the cleaning cartridge.
Table 7-2. Error Displays and Instructions (Continued)