StorageTek 9840 - Manual (Page 67)

95741 Sixth Edition 3-17
9738 Library Attachment
CAUTION:
Connector damage. Be careful not to bend or damage the pins or connectors when
connecting the cable to the drive.
2. Connect the host SCSI cable to the lower 68-pin jack on the drive (see figure).
Note: You might want to connect the host SCSI cable to the 9738 library and daisy-chain
from the library to the 9840. If this describes your configuration, refer to the 9738
Product Manual for cabling instructions.
1. SCSI interface cable
3. If you are not going to daisy-chain drives, skip to Step 5.
Note: If you are daisy-chaining drives, locate a daisy-chain cable (PN 10083599)
in the hardware kit.
4. Connect one end of the cable to the top 68-pin jack on the drive tray, and connect the
other end of the cable to the bottom jack of the higher drive tray (see figure).
Note: If you are daisy chaining all three drives within the library, use another daisy-
chain cable and connect the upper 68-pin jack on the middle drive to the lower
68-pin jack on the upper drive.
1. Host interface connection
2. SCSI daisy-chain cable (Drive 0 to 1)
3. SCSI daisy-chain cable (Drive 1to 2)
4. SCSI terminator
E53252
1
C53370
4
3
2
1