StorageTek 9840 - Manual (Page 137)

95741 Sixth Edition 5-21
Modes of Operation
Note: If the cartridge is not inserted into the CSL feed channel properly
( Figure 5-15 ), the CSL cannot insert the cartridge into the drive slot.
3. Check to ensure the operator indicator is flashing.
4. Press the Start switch to feed the cartridge into the drive and to clear the
flashing operator indicator.
CSL in Automatic Mode
The automatic mode is used for sequential mounting of cartridges from the
input bin into the drive. When the CSL is in the automatic mode and the drive is
not loaded, follow these procedures to load a priority cartridge:
1. If there are no cartridges in the input bin, the operator indicator flashes to
signal you to insert a priority (single) cartridge into the feed channel. Press
the
Start switch to resume CSL operation.
2. If the input bin is not empty, the mode must be changed to manual mode to
mount the priority cartridge. This prevents the next cartridge from being
automatically loaded.
Note: Refer to Figure 5-15 to correctly load a cartridge into the feed channel
Figure 5-15. Priority Mount Cartridge
1. Cartridge
2. First index rod
3. Cartridge stop mechanism
C53665
3
1
2