StorageTek 9840 - Manual (Page 68)

9738 Library Attachment
3-18 Sixth Edition 95741
Apply Power to Library Drive
1. Turn on the power switch of each 9840 Tape Drive power supply.
2. Connect the library power cord to a power source and enable the power
switch.
3. Verify that the drives power on.
Install a Cleaning Cartridge
Use the instructions below to apply the label to a cleaning cartridge:
5. Install the terminator (part number 10148003) either at the top jack at the rear of the
drive tray or to the device at the end of the SCSI bus.
6. Repeat steps 2 through 5, as they apply to the bus configuration, for any other drive.
7. Proceed to “Apply Power to Library Drive” on page 3-18 .
1. Obtain the cleaning cartridge label.
2. Label a cleaning cartridge (identified by a “U” in the media ID area) by attaching a
DG CLN label to the VOLSER label area (see figure).
1. VOLSER label area
2. Media ID area
3. The cleaning cartridge will be installed in Column 0 Row 7. Refer to the 9738
documentation to enable auto cleaning.
4. Proceed to “Configure the Drive” on page 3-53 .
C53373
1
2