StorageTek 9840 - Manual (Page 79)

95741 Sixth Edition 3-29
Rack
Open the Rear Door
Follow the instructions below to open the rear door of the rack.
Install Optional Second Power Strip
Follow the instructions below to install a second power strip when more than
four trays are to be powered in the equipment rack.
1. Lift the lock shield (see figure below).
2. If locked, use the key to unlock the door.
3. Press on the key cylinder and the door handle pops out.
4. Turn door handle counter-clockwise to unlatch, and open door by pulling on the handle.
1. Lock shield
2. Key cylinder
3. Door handle
1. Unpack the power strip and mounting hardware.
2. If required, open the rack rear door.
3. Install captive nuts into holes 12 and 14, above the existing power strip.
Note: Make sure captive nuts are installed on both vertical frame members.
4. Position second power strip, and secure with four screws.
E53254
1
2
3