Sun Microsystems 6900 - Manual (Page 102)

82 Sun StorEdge 3900 and 6900 Series 2.0 Troubleshooting Guide • March 2003
Sun Proprietary/Confidential: Internal Use Only
TABLE 7-2 lists the switch events for Sun StorEdge network FC switch-8 and switch-
16 2 Gbit switches.
TABLE 7-2 Storage Automated Diagnostic Environment Event Grid for 2 GBit Switches
Component EventT
ype
Se
verity
Action Description Note: T
e
xt
within
quotation
marks
(“
“)
is
e
xactl
y
as
it
appear
s
o
n
the
Event
Grid.
Action Required
chassis.
fan Alarm- Yellow Y “chassis.fan.1 status
changed from OK” None.
chassis.
board Alarm- Yellow Y The uptime of the switch
was less than the previous
uptime of the switch. This
could indicate that the
switch has been reset either
by a user or by the loss of
power. 1. Check to see if the switch
has been reset.
2. Check the power going
to the switch.
chassis.
power Alarm Yellow “chassis.power.1 status
changed from OK”
This event monitors
changes in the status of the
chassis’ power supply, as
reported by the SANbox
chassis status.
None.
system_
reboot Alarm Yellow “Switch sw1a was rezoned”
This event reports changes
in the zoning of a switch.
enclosure Audit “Auditing a new switch
called
ras d2-swb1
(ip=xxx.0.0.41)
10002000007a609”
oob Comm_
Established “Communication regained
with
sw1a
(ip= xxx. 20.67.213)”