Panasonic AV-HS450N - Manual (Page 116)

116
4. Input/output signal settings
Turn [F5] to select the scaling method, and press the [F5] switch to enter the selection.
Fit-V: The aspect ratio of the output images is maintained, and the size of the images is increased or
reduced in accordance with the vertical resolution.
(Black bands are inserted into the areas where there are no images. The protruding parts of the
images are cropped.)
Fit-H: The aspect ratio of the output images is maintained, and the size of the images is increased or
reduced in accordance with the horizontal resolution.}
(Black bands are inserted into the areas where there are no images. The protruding parts of the
images are cropped.)
Full: The size of the output images is increased or reduced in accordance with the system resolution.
(The aspect ratio of the output images is not maintained. The rate at which the image size is
increased or reduced in the vertical direction differs from that in the horizontal direction.)
 Select the settings below is cases where DVI-D signals (OUT5 and OUT6) are output.
Turn [F2] to display the Asign sub menu.
<Menu display>
OUTPUTYY|Asign |Souce |MovDet↓|
| 1/2 | PGM|
 3|
PVW
CLN
AUX1~4
MV1,MV2
KeyOut 1~5
Turn [F4] to set the video movement detection sensitivity using the MovDet item, and press the [F4] switch
to enter the setting.
1: Sensitivity closer to still image — 3: standard — 5: sensitivity closer to moving images